Welcome To Hebei Jiaoyang Wire Mesh Machine Co., Ltd.                    weldingmachine@jiaoyangen.net          +86-318-7063110
You are here: Home » News » Common fault phenomenon and quick treatment » The wire mesh trolley of the mesh welded machine does not work

Contact Us

Add: no.28 weier road,eastern industrial         zone,anpingcounty,hebei 
E-mail:
weldingmachine@jiaoyangen.net
Tel: +86-318-7063110

The wire mesh trolley of the mesh welded machine does not work

Views:0     Author:Site Editor     Publish Time: 2018-12-19      Origin:Site Inquire

Fault phenomenon 5: The mesh welded machine is responsible for pulling the mesh moving motion.

Causes and elimination of faults: 1.Responsible for controlling the stepper motor driver power switch does not open (control cabinet stepper motor switch);2.Stepper motor driver input power fuse fuse;3.Stepper motor driver to motor Poor contact of the output line, insufficient current in the stepper motor driver or the controller has entered the protection state;4.The stepper motor is used for too long under overload conditions, and the drive controller is overheated.

If the above fault occurs,it should be adjusted and checked according to the instruction manual attached.


Product Inquiry
Hebei Jiaoyang Wire Mesh Machine Co.,ltd.
Add: no.28 weier road,eastern industrial zone,anpingcounty,hebei 
Email:
weldingmachine@jiaoyangen.net
Tel: +86-318-7063110
Copyright
 2017 Hebei Jiaoyang Wire Mesh Machine Co., Ltd.  All rights reserved.
Support by 
Rongchuangmedia  
sitemap.xml

Quick Navigation

Product Category