Welcome To Hebei Jiaoyang Wire Mesh Machine Co., Ltd.                    weldingmachine@jiaoyangen.net          +86-13932830858
You are here: Home » News » Common fault phenomenon and quick treatment » The cross wire cannot be properly attached to the positioning magnet

Contact Us

Add: no.28 weier road,eastern industrial         zone,anpingcounty,hebei 
E-mail:
weldingmachine@jiaoyangen.net
Tel: +86-318-7063110

The cross wire cannot be properly attached to the positioning magnet

Views:4     Author:Site Editor     Publish Time: 2018-12-23      Origin:Site Inquire

Fault phenomenon 9:The cross wire of mesh welding machine can not be properly picked up on the positioning magnet

Causes and elimination of the fault:1.The groove width of the weft wire is not suitable or has been seriously worn;2.The air leakage of the cylinder is slowed down by the cylinder,and the speed of the cylinder is slowed down;3.The pressure or flow of the cylinder is too small,and the strength of the wire is not enough;The positioning angle of the twisted wire shaft and the twisting wheel changes,and needs to be re-tuned.


Product Inquiry
Hebei Jiaoyang Wire Mesh Machine Co.,ltd.
Add: no.28 weier road,eastern industrial zone,anpingcounty,hebei 
Email:
weldingmachine@jiaoyangen.net
Tel: +86-13932830858
Copyright
 2017 Hebei Jiaoyang Wire Mesh Machine Co., Ltd.  All rights reserved.
Support by 
Rongchuangmedia  
sitemap.xml

Quick Navigation

Product Category