Steel reinforcing mesh machine wholesale

The China mesh reinforcement machine exporter, Jiaoyangspecializes in the production of equipment. The welding control of the Reinforcing Mesh Production Welding Machine produced by the Jiaoyang wire mesh equipment adopts computer control, which achieves accurate welding time, current balance and low failure rate.

1. The Welding host of Reinforcing Mesh Production Welding Machine adopts imported famous brand pneumatic components, which has long service life, high precision and high pressure, which promotes firm solder joints.

2. The welding transformer adopts a new type of high-efficiency welded mesh transformer. The shifting gear can be divided into eight grades, which expands the range of welding wire diameter. Professional design of the lower electrode block, low wear rate, and multi-faceted use.

3. The netting system of steel reinforcing mesh machine uses computer programming control, the horizontal rib spacing is infinitely adjusted, and the changing hole pitch is set by the program. There can be a variety of different transverse rib spacing on the same mesh.

4. The control system of steel reinforcing mesh machine adopts PLC programming controller, touch display, convenient operation interface and simple working mode.

5.The blanking system adopts the patented technology, the single root is single, the barrel is blanked, and no manual placement is required.

6. The reinforcement mesh has a wide range of uses and has been widely used in industrial and civil buildings for floor slabs, roofs, walls, bridges, concrete pavements, floors, airports, cement pipes, concrete prefabricated parts, retaining walls, mountain slopes, tunnels, Docks, dams, etc.

Specific parameters of Reinforcing Mesh Production Welding Machine:

1 The maximum welded mesh width is 3300mm, and the welded steel bar diameter is 3mm-12mm;

2 diameter wire spacing ≥ 50mm, any adjustable

3 weft hole spacing ≥ 50mm, any adjustable

4 welding transformer air self-cooling (or water cooling), power greater than 1500KVA, can achieve a single compression, divided welding;

Model use: Production of coal mine underground support mesh, welding diameter 4mm~7mm, mesh size up to 2m*6m (over-range customer reservation).